Are they off by a factor of 2? If so, this is due to the
OPAL_RUBY_MULTIPLIER setting in ruby/config/rubyconfig.defaults
--Mike
> I am running a CMP system (2 procs on 1 chip) with Serengeti/Solaris
> target (mostly default configuration). I use both Opal and Ruby for a
> simulation of running a few binaries for 1 million steps. When I look
> at the statistics in Ruby, I see Instructions per cycle per processor,
> which I assume I can take the inverse to get Cycles Per Instruction).
> However these numbers do not match the CPI's I get in Opal's report.
> Why are they different?
>
>
>
>
>
>
>
>
|