Mailing List Archives
Public Access
|
|
|
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [HTCondor-users] NETWORK_INTERFACE and condor_status
- Date: Thu, 20 Aug 2015 18:02:21 -0500
- From: Todd Tannenbaum <tannenba@xxxxxxxxxxx>
- Subject: Re: [HTCondor-users] NETWORK_INTERFACE and condor_status
On 8/20/2015 3:55 PM, Thomas B Winans wrote:
Hello -
I recently added NETWORK_INTERFACE to my condor_config.local, and then
subsequently could not successfully invoke condor_status without getting
the error “CEDAR:6001:Failed to connect to <127.0.0.1:9618>”. Is there
an explanation for this? Most likely it is my error, but it does not
seem obvious…
Many thanks,
Tom
Hi Tom,
NETWORK_INTERFACE is one of the (rare) config settings that cannot be
changed on the fly... you need to shutdown HTCondor, change
NETWORK_INTERFACE, and then restart up HTCondor again.
Also note that setting NETWORK_INTERFACE=127.0.0.1 means that you truly
have a condor pool of one node - no HTCondor tools or daemons will
communicate over the network.
Todd
Tom Winans
tbw@xxxxxxxxxxxx <mailto:tbw@xxxxxxxxxxxx>
http://tomwinans.info
_______________________________________________
HTCondor-users mailing list
To unsubscribe, send a message to htcondor-users-request@xxxxxxxxxxx with a
subject: Unsubscribe
You can also unsubscribe by visiting
https://lists.cs.wisc.edu/mailman/listinfo/htcondor-users
The archives can be found at:
https://lists.cs.wisc.edu/archive/htcondor-users/
--
Todd Tannenbaum <tannenba@xxxxxxxxxxx> University of Wisconsin-Madison
Center for High Throughput Computing Department of Computer Sciences
HTCondor Technical Lead 1210 W. Dayton St. Rm #4257
Phone: (608) 263-7132 Madison, WI 53706-1685