Hello,
As suggested, I switch from simics 3 to simics2. I am using simics-2.2.19-x86-linux
and following the instruction on “Setting up your GEMS environment”
(http://www.cs.wisc.edu/gems/doc/wiki/moin.cgi/Setup),
when I get to step 3, running the configure, and get an error. At first I
think this is due to I am not using bash. So I changed my shell to bash and error
comes again. I am very new to Linux and GEMS, so I don’t know what’s
going on there. What do you guys normally do when running in this step? Do I
have to modify configure? BTW, my system is using gcc4.1 default and I have
gcc-3.3 installed. I am using ubuntu.
Here is the output:
yzheng@yzheng-desktop:~/gems-release1.3.1/simics/x86-linux$
../configure CC=gcc-3.3 CXX=g++-3.3
configure: Setting up environment variables...
configure: Examining Simics source directory...
configure: Doing sanity checks on the source directory...
checking for Simics host type... x86-linux
checking for bash... /bin/bash
checking for gmake... no
checking for make... /usr/bin/make
configure: loading host defaults:
/home/yzheng/gems-release1.3.1/simics/config/host-defaults.common
configure: loading host defaults:
/home/yzheng/gems-release1.3.1/simics/config/host-defaults.x86-linux
checking for perl... /usr/bin/perl
checking Perl version... ok (5.8.8)
parsing: /home/yzheng/gems-release1.3.1/simics/config/host-flags.common
parsing:
/home/yzheng/gems-release1.3.1/simics/config/host-flags.x86-linux
parsing: /home/yzheng/gems-release1.3.1/simics/config/host-flags.optional
checking whether /usr/bin/make sets ${MAKE}... yes
checking for CC... (already defined) gcc-3.3
checking installation prefix of compiler... configure: error: Don't
know how to run 'type' on this host.
Thanks in
advance.
|
|