Re: [Gems-users] Configure Simics for host


Date: Fri, 12 Jan 2007 08:39:21 -0600 (CST)
From: Mike Marty <mikem@xxxxxxxxxxx>
Subject: Re: [Gems-users] Configure Simics for host
I would ask this question on the simics.net forums

--Mike


> Hello,
>
>
> As suggested, I switch from simics 3 to simics2. I am using
> simics-2.2.19-x86-linux and following the instruction on "Setting up your
> GEMS environment" (http://www.cs.wisc.edu/gems/doc/wiki/moin.cgi/Setup),
> when I get to step 3, running the configure, and get an error.  At first I
> think this is due to I am not using bash. So I changed my shell to bash and
> error comes again. I am very new to Linux and GEMS, so I don't know what's
> going on there. What do you guys normally do when running in this step? Do I
> have to modify configure? BTW, my system is using gcc4.1 default and I have
> gcc-3.3 installed. I am using ubuntu.
>
>
> Here is the output:
>
>
> yzheng@yzheng-desktop:~/gems-release1.3.1/simics/x86-linux$ ../configure
> CC=gcc-3.3 CXX=g++-3.3
>
>
> configure: Setting up environment variables...
>
>
> configure: Examining Simics source directory...
>
>
> configure: Doing sanity checks on the source directory...
>
>
> checking for Simics host type... x86-linux
>
>
> checking for bash... /bin/bash
>
>
> checking for gmake... no
>
>
> checking for make... /usr/bin/make
>
>
> configure: loading host defaults:
> /home/yzheng/gems-release1.3.1/simics/config/host-defaults.common
>
>
> configure: loading host defaults:
> /home/yzheng/gems-release1.3.1/simics/config/host-defaults.x86-linux
>
>
> checking for perl... /usr/bin/perl
>
>
> checking Perl version... ok (5.8.8)
>
>
> parsing: /home/yzheng/gems-release1.3.1/simics/config/host-flags.common
>
>
> parsing: /home/yzheng/gems-release1.3.1/simics/config/host-flags.x86-linux
>
>
> parsing: /home/yzheng/gems-release1.3.1/simics/config/host-flags.optional
>
>
> checking whether /usr/bin/make sets ${MAKE}... yes
>
>
> checking for CC... (already defined) gcc-3.3
>
>
> checking installation prefix of compiler... configure: error: Don't know how
> to run 'type' on this host.
>
>
> Thanks in advance.
>
>
>
>
>
>
[← Prev in Thread] Current Thread [Next in Thread→]