Re: [Condor-users] Condor Jobs System use

["Koller, Garrett" <kollerg14@xxxxxxxxxxxx>]

If I were you, I would look into setting up CondorView.  I don't know how specific it is to each job, but from what I understand it helps you to visualize the happenings of your Condor system in an easy-to-use web interface.  I think it comes with the standard installation of Condor, so all you have to do is enable it.  For more information about how to install CondorView, look it up in the documentation at http://www.cs.wisc.edu/condor/manual/v7.6/3_2Installation.html#SECTION00429000000000000000 .
Does this answer your question?

Best Regards,
 - Garrett Koller

Washington and Lee University

---

From: condor-users-bounces@xxxxxxxxxxx [condor-users-bounces@xxxxxxxxxxx] on behalf of 关中大侠 [969041723@xxxxxx]
Sent: Sunday, August 14, 2011 9:03 PM
To: Condor-Users Mail List
Subject: Re: [Condor-users] Condor Jobs System use

Sorry, I am a beginner and I can't answer your question.
I will think it again when I have knowledge of the question, and you may ask other to give you an answer.
Best wishes!

 

 

------------------ Original ------------------

From:  "Edier Zapata"<edalzap@xxxxxxxxx>;

Date:  Fri, Aug 12, 2011 01:09 AM

To:  "condor-users"<condor-users@xxxxxxxxxxx>;

Subject:  [Condor-users] Condor Jobs System use

 

Good afternoon,
I want to know if there's a way or tool to check and/or store the current System use of a job in the pool?
System use means: RAM, Disk, CPU, etc.

Thank you

--
Edier Alberto Zapata Hernández
Ingeniero de Sistemas
Universidad de Valle