RE: [condor-users] GetCursorPos Error in Startlog

[Campbell Bradley L CRBE <CampbellBL@xxxxxxxxxxxxxxx>]

I am using version 6.4.7. 

Brad


-----Original Message-----
From: Alain Roy [mailto:roy@xxxxxxxxxxx]
Sent: Wednesday, October 08, 2003 5:48 PM
To: condor-users@xxxxxxxxxxx
Subject: Re: [condor-users] GetCursorPos Error in Startlog



>I have a cluster of WinXP machines that use a KVM switch.  Two of the 15 
>identical machines show up in condor_status but never take jobs.  In the 
>startlog file on each of these computers there is a GetCursorPos error.

We've seen this before, but have been unable to track it down. Which 
version of Condor are you using? Condor 6.5.5 reports a specific error 
number when it reports this, but earlier versions didn't. If we could get 
this error number, we may be able to figure out the problem.

We have some Windows machines on a KVM, but haven't experienced the problem 
ourselves.

-alain


Condor Support Information:
http://www.cs.wisc.edu/condor/condor-support/
To Unsubscribe, send mail to majordomo@xxxxxxxxxxx with
unsubscribe condor-users <your_email_address>
Condor Support Information:
http://www.cs.wisc.edu/condor/condor-support/
To Unsubscribe, send mail to majordomo@xxxxxxxxxxx with
unsubscribe condor-users <your_email_address>