No. Also, I redo the experiment and see that the number of unknown
instructions is small. As Nauman mentioned, I also believe the results
have not be effected too much.
On 4/11/05, Nauman Rafique <nrafique@xxxxxxxxxx> wrote:
> I am getting the same message, while running apache. Opal does not stop. I am
> assuming that the simulation results would not be effected too much, as the
> state is kept in sync with simics?
>
> --
> Nauman
>
>
> Quoting Mike Marty <mikem@xxxxxxxxxxx>:
>
> > Weihang,
> >
> > Does this cause Opal to stop?
> >
> > --Mike
> >
> >
> > > Hi,
> > > I am runing DB2 on SIMICS/GEMS. Opal printed out :###
> > > statici::decodeFails. line:3274. inst=0xff2c07a8
> > >
> > > 1111 1111 0010 1100:0000 0111 1010 1000
> > >
> > > As SPARC V9 manual says, rd (bit 29 to 25) should be 0 or 1. (So
> > > does opal think) I am not sure why here rd is "11111", which is
> > > reserved.
> > >
> > > Since you have run DB2 before, maybe you have some idea.
> > >
> > > --
> > > Weihang Jiang
> > > _______________________________________________
> > > Gems-users mailing list
> > > Gems-users@xxxxxxxxxxx
> > > https://lists.cs.wisc.edu/mailman/listinfo/gems-users
> > >
> > _______________________________________________
> > Gems-users mailing list
> > Gems-users@xxxxxxxxxxx
> > https://lists.cs.wisc.edu/mailman/listinfo/gems-users
> >
>
> _______________________________________________
> Gems-users mailing list
> Gems-users@xxxxxxxxxxx
> https://lists.cs.wisc.edu/mailman/listinfo/gems-users
>
--
Weihang Jiang
|