Re: [Gems-users] Unknown SPARC Instructions in OPAL

[Nauman Rafique <nrafique@xxxxxxxxxx>]

I am getting the same message, while running apache. Opal does not stop. I am
assuming that the simulation results would not be effected too much, as the
state is kept in sync with simics?

-- 
Nauman


Quoting Mike Marty <mikem@xxxxxxxxxxx>:

> Weihang,
> 
> Does this cause Opal to stop?
> 
> --Mike
> 
> 
> > Hi,
> >     I am runing DB2 on SIMICS/GEMS. Opal printed out :###
> > statici::decodeFails. line:3274. inst=0xff2c07a8
> >
> > 1111 1111 0010 1100:0000 0111 1010 1000
> >
> >    As SPARC V9 manual says, rd (bit 29 to 25) should be 0 or 1. (So
> > does opal think) I am not sure why here rd is "11111", which is
> > reserved.
> >
> >    Since you have run DB2 before, maybe you have some idea.
> >
> > --
> > Weihang Jiang
> > _______________________________________________
> > Gems-users mailing list
> > Gems-users@xxxxxxxxxxx
> > https://lists.cs.wisc.edu/mailman/listinfo/gems-users
> >
> _______________________________________________
> Gems-users mailing list
> Gems-users@xxxxxxxxxxx
> https://lists.cs.wisc.edu/mailman/listinfo/gems-users
>