Date: | Thu, 31 Aug 2006 09:46:04 -0700 (PDT) |
---|---|
From: | Forum Forum <forum_86@xxxxxxxxx> |
Subject: | Re: [Gems-users] rubu0.init step fails: how can I debug this: |
Hi Dan: I tried without those 2 commands and still if fails in the same point - is there a way to debug why it is failing. I mean, can I look at some files (log/etc) to see what is the reason it failed. Thanks, Ataur. [patwarya@chipdesign ~/GEMS]$ cd $GEMS/simics/home/MOSI_SMP_bcast [patwarya@chipdesign MOSI_SMP_bcast]$ ./simics -stall simics> read-configuration /home/patwarya/GEMS/simics-2.2.19/home/firststeps/fs-config-5 simics> dstc-disable Turning D-STC off and flushing old data simics> load-module ruby simics> ruby0.setparam g_NUM_PROCESSORS 1 simics> ruby0.setparam g_MEMORY_SIZE_BYTES 4294967296 simics> ruby0.init Ruby Timing Mode Creating event queue... Creating event queue done Creating system... Processors: 1 Killed [patwarya@chipdesign MOSI_SMP_bcast]$ Dan Gibson <degibson@xxxxxxxx> wrote: x86 targets don't allow stalling of instruction fetch... can you try again without the "instruction-fetch-mode instruction-fetch-trace" and "istc-disable" steps?
Stay in the know. Pulse on the new Yahoo.com. Check it out. |
[← Prev in Thread] | Current Thread | [Next in Thread→] |
---|---|---|
|
Previous by Date: | Re: [Gems-users] Ruby statistics - No L1 cache miss ???, mehmetderin . harmanci |
---|---|
Next by Date: | Re: [Gems-users] rubu0.init step fails: how can I debug this:, Dan Gibson |
Previous by Thread: | Re: [Gems-users] rubu0.init step fails: how can I debug this:, Dan Gibson |
Next by Thread: | Re: [Gems-users] rubu0.init step fails: how can I debug this:, Dan Gibson |
Indexes: | [Date] [Thread] |