Date: | Thu, 31 Aug 2006 00:02:35 -0700 (PDT) |
---|---|
From: | Forum Forum <forum_86@xxxxxxxxx> |
Subject: | [Gems-users] rubu0.init step fails: how can I debug this: |
Hi: I am using GEMS (Release 1.1 for GEMS and SIMICS 2.2) for x86 target/host machine in Linux - I used the patch for x86. I am following the quick steps as given in: http://www.cs.wisc.edu/gems/doc/wiki/moin.cgi/QuickStart I used the checkpoint file which is taken from (I am not sure this has something to do with the failure that I am seeing): $GEMS/simics-2.2.19/home/firststeps/fs-config-1 I did the following commands and found the job to be killed after I applied ruby0.init command. The details are given below. Please let me know how I can debug this or if I am not doing it right somewhere: -------------------------------------------------------------------------------------------------------------------- [patwarya@chipdesign MOSI_SMP_bcast]$ ./simics -stall simics> read-configuration /home/patwarya/GEMS/simics-2.2.19/home/firststeps/fs-config-5 Then I got a pop-up window with title as: Simics Console: con0 The Debian GNU/Linux is booted. Then I applied following commands: simics> instruction-fetch-mode instruction-fetch-trace simics> istc-disable simics> dstc-disable simics> load-module ruby simics> ruby0.setparam g_NUM_PROCESSORS 1 simics> ruby0.setparam g_MEMORY_SIZE_BYTES 4294967296 simics> ruby0.init Ruby Timing Mode Creating event queue... Creating event queue done Creating system... Processors: 1 Killed [patwarya@chipdesign MOSI_SMP_bcast]$ Thanks, Ataur.
Yahoo! Messenger with Voice. Make PC-to-Phone Calls to the US (and 30+ countries) for 2¢/min or less. |
[← Prev in Thread] | Current Thread | [Next in Thread→] |
---|---|---|
|
Previous by Date: | Re: [Gems-users] NUCA Profiler, Mishali Naik |
---|---|
Next by Date: | Re: [Gems-users] NUCA Profiler, Daniele Bordes |
Previous by Thread: | [Gems-users] question on nuca model, Mishali Naik |
Next by Thread: | Re: [Gems-users] rubu0.init step fails: how can I debug this:, Dan Gibson |
Indexes: | [Date] [Thread] |