Johnson koil Raj wrote:
> Just compare the Requirements you are setting for the job both submitted
> through SOAP and command line. If it miss something add.
> 倪翔 wrote:
>> Dear all, I use SOAP api to submit job to condor pool and query its
>> status to determine whether the job has been completed. I have to wait
>> for nearly* 7 minutes* until the job transfer its status from IDLE to
>> RUNNING. However, If I submit the job using command line, it will be
>> completed in a few seconds. Does anyone meet this problem before or
>> know how to solve the problem? Did I need to add something special in
>> the config file?
>> Xiang Ni
>> Sino-German Joint Software Institute
>> Computer Science&Engineer Deparment of Beihang University
>> Condor-users mailing list
>> To unsubscribe, send a message to condor-users-request@xxxxxxxxxxx
>> subject: Unsubscribe
>> You can also unsubscribe by visiting
>> The archives can be found at:
> Please do not print this email unless it is absolutely necessary.
> The information contained in this electronic message and any attachments to this message are intended for the exclusive use of the addressee(s) and may contain proprietary, confidential or privileged information. If you are not the intended recipient, you should not disseminate, distribute or copy this e-mail. Please notify the sender immediately and destroy all copies of this message and any attachments.
> WARNING: Computer viruses can be transmitted via email. The recipient should check this email and any attachments for the presence of viruses. The company accepts no liability for any damage caused by any virus transmitted by this email.
> Condor-users mailing list
> To unsubscribe, send a message to condor-users-request@xxxxxxxxxxx
> subject: Unsubscribe
> You can also unsubscribe by visiting
> The archives can be found at:
Condor-users mailing list
To unsubscribe, send a message to condor-users-request@xxxxxxxxxxx
You can also unsubscribe by visiting
The archives can be found at: