Re: [Condor-users] Getting cpuinfo in standard universe jobs

["Timothy St. Clair" <tstclair@xxxxxxxxxx>]

There is not detailed information in the SlotAd until it is
checkpointed, even then it is limited.

If you're looking for matching requirements, there are benchmarks which
you can use:

Mips
KFlops

To see the slog of information presented by your slots you can type:

condor_status -long <- gives you everything
condor_status -long slotXYZ <- gives you detailed info about a slot.

If your request goes beyond *this you may want to append to:
https://condor-wiki.cs.wisc.edu/index.cgi/tktview?tn=2343

Hope this helps,
Tim

On Thu, 2011-08-11 at 15:13 -0400, Ka-Hei Law wrote:
> Dear all,
> 
> How can I get the CPU information (model and speed) on the nodes where
> my standard universe jobs are executed? They are x86-64 Linux nodes.
> 
> I tried reading "/proc/cpuinfo" using stdio functions in C, but the
> "file" seems to be empty for standard universe jobs. Perhaps reading
> the proc fs isn't supported in the standard universe.
> 
> I found that the CPUID opcode (http://en.wikipedia.org/wiki/CPUID) may
> give me what I need. Do you think it will work in my case? If yes, do
> you think it's the way to go? Or would you suggest other alternatives?
> 
> Thanks,
> Ka-Hei Law
> _______________________________________________
> Condor-users mailing list
> To unsubscribe, send a message to condor-users-request@xxxxxxxxxxx with a
> subject: Unsubscribe
> You can also unsubscribe by visiting
> https://lists.cs.wisc.edu/mailman/listinfo/condor-users
> 
> The archives can be found at:
> https://lists.cs.wisc.edu/archive/condor-users/