Re: [HTCondor-users] Syntax error in Job_router_entries

[Brian Bockelman <bbockelm@xxxxxxxxxxx>]

Hi Carles,

I'm sure I'll regret it because the line will be huge, but --

Can you send out the full JOB_ROUTER_ENTRIES (i.e., output of "condor_config_val JOB_ROUTER_ENTRIES")?  I don't see anything obvious in the snippet you sent below, so I'm hoping more context will help provide the answer.

Thanks!

Brian

On Aug 28, 2017, at 11:06 AM, Carles Acosta <cacosta@xxxxxx> wrote:

Dear all,

We are installing a new HTCondor-CE (3.0.1-1) in CentOs7 with HTCondor version 8.6.5.

We cannot start the condor-ce service, it fails with the next error:

Aug 28 17:21:28 ce14.pic.es condor_ce_startup[461853]: ERROR: Could not read JOB_ROUTER_ENTRIES in the HTCondor CE configuration. Please verify syntax correctness

After some trial and error checking, it seems that this is the problematic line:

set_LivAcctSubGroup = strcat(regexps("([A-Za-z0-9]+[A-Za-z])\\d+", Owner, "\\1"),ifThenElse(RequestCpus > 1,"_mcore","_score"));\

The same line works perfectly fine with our other HTCondor-CE 2.1.2... Is there any change regarding the syntax check in new HTCondor-CE versions?

Thank you in advance.

Best regards,

Carles

_______________________________________________
HTCondor-users mailing list
To unsubscribe, send a message to htcondor-users-request@xxxxxxxxxxx with a
subject: Unsubscribe
You can also unsubscribe by visiting
https://lists.cs.wisc.edu/mailman/listinfo/htcondor-users

The archives can be found at:
https://lists.cs.wisc.edu/archive/htcondor-users/