[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [condor-users] getting the demons to listen on a differentinterface

Have you tried to set NETWORK_INTERFACE = in the config file?


On 05/06/2004 04:45 PM, Martin L. Purschke wrote:
I have two sets of machines, one on the public network, and one on a RFC1982 network. The central manager runs on a gateway machine so it can later talk to both networks easily (and for now, in order to have the CM accessible from the public network w/o hopping through yet another gateway).

> [root]# ifconfig
> eth0 Link encap:Ethernet HWaddr 00:30:48:71:1D:6B
> inet addr:xxx.xxx.xxx.xxx Bcast:xxx.xxx.xxx.xxx Mask:
> eth1 Link encap:Ethernet HWaddr 00:30:48:71:1D:6A
> inet addr: Bcast: Mask:

Now I could not find a way to have the demons (negotiator etc) listen on the private interface. The ports 9614 and 9618 and so on are open on the primary eth0 interface only. The CONDOR_HOST and similar entries seem to *tell about* the whereabouts of the host/interface, but not actually instruct any demon to use a particular interface. Eventually the challenge will be to have the demons accept requests on both interfaces, but for now I'm looking for a way to bind them to eth1. Is there a way to do that?



Condor Support Information: http://www.cs.wisc.edu/condor/condor-support/ To Unsubscribe, send mail to majordomo@xxxxxxxxxxx with unsubscribe condor-users <your_email_address>